Ensure service pipes and wires are fixed or checked into the frame and not laid loose in the extended wall cavity. All materials that are susceptible to deterioration due to plasticiser migration must be protected (check with product manufacturer). Some PVC products or electrical cabling that penetrate the coating system and QT EcoSeries Wall Panel, require a conduit to ensure it is protected.
Copper pipes require a sleeve, conduit or tape to prevent contact with the wall panel.
Voids or gaps created by service penetrations through the exterior wall require weatherproofing and or waterproofing.
A commonmethod is to inject with expandable polyurethane foam and seal with a long lasting exterior gap sealant to make a weather tight seal. Where practical add a flange or decorative feature over the hole or penetration.
Use an exterior grade weatherproof sealant for exterior wall construction and as a general-purpose gap filling.
Apply sealant in accordance to manufacturers recommendations. For a sealant to work effectively, the sealant must be applied as shown in the sketch below, Opening Width (D) x Depth (D/2) half the width. Use backing rodas required. Ensure surfaces are in good condition clean and free from oil, dust, loose materials including old sealant and release agents.
Apply masking tape to surfaces where contact with sealant is not required. Tape should be removed before sealant cures. Smooth the surface of the sealant and ensure excess sealant is removed. Refer manufacturers curing or drying times before painting.
Heavy items are not to be fitted directly to the QT EcoSeries WallPanel. They should have their own stand-alone supports or be tied to the supporting wall frame (eg. Clothes lines). Items subject to frequent handling (e.g. Flood-Lights and sensors) require a mounting plate, to be fixed across at least two or more frame studs to give long term fixing support. The backing plate must be of a material that will offer, long-term weatherproof durability. If the internal lining is already installed, the mounting plate can be installed externally prior to the installation of the QT EcoSeries Wall Panel.